New Risk Racing Lock N Load Strapless Tie-Down System
The Risk Racing Lock N Load Moto Anchoring System securely holds your motocross bike into your van or trailer without the use of tie-down straps, floor anchors or wheel chocks. It takes an enormous amount of pressure off of the fork seals during transit, and it frees up valuable space allowing the transport of more motorcycles or gear. Additionally, the Lock and Load can quickly be removed from the trailer floor by unscrewing the 4 thumb screws leaving only the low profile mounting plates. Each plate has a ring for additional anchor points on your trailer floor.
Risk Racing Lock N Load Features:
Saves fork seals by drastically reducing fork seal pressures. Leave your bike in your van or trailer overnight!
No more web of straps, wheel chocks or floor anchors. This is a much simpler and cleaner solution. Load more bikes and gear in your truck or trailer.
Load bikes shroud to shroud, 4 bikes wide in a trailer!
Quick release from trailer floor. Only the low profile plates with extra Ring remain on the floor.
Foot print: 18"x9" (45.72cm)
No tie-down straps, floor anchors, wheel chocks
The Lock-N-Load is designed for use with 125cc- 450cc modern motocross specific bikes, or bikes with similar geometry regarding foot peg width and height.
Includes Fitting Kit for Installation
1 - To operate the Lock N Load, rotate the knobs into the lock position and simply roll or ride your bike into the trailer until your foot pegs hit the open jaws of the Lock N Load.
2 - Then step on the upper jaws and they will automatically lock into place.
3 - To release your bike, simply rotate the knobs into the release position and step on the top jaws.
4 - This will automatically release the jaws and free your motorcycle.
5 - For additional safety, insert the attached locking pins prior to transport. You can replace the locking pins with pad locks for added security and a theft deterrent.